FRS-2000
FURUISI
Color/LOGO/outer packaging customization is the minimum order quantity of one ton.
| Quantity: | |
|---|---|
PRODUCT DATA
FRS-2000 Interior wall coating
1 、Product Description：
Silicone interior wall solvent-free coating, non-corrosive, alcohol-cured, non-volatile, waterproof function, can be used for indoor latex paint replacement. The product has flame retardant, high and low temperature resistance, ultraviolet resistance, salt spray resistance, oil and water resistance, easy cleaning, excellent adhesion and compatibility.
ingredient | One-component |
strength | Medium intensity |
Curing mechanism | Moisture cures |
apply | Flat seal, waterproof and flame retardant |
2 、Typical uses：
It is suitable for the use of interior walls of various buildings, such as: home decoration, kindergartens, nursing homes, confinement centers, hospitals, hotels and large supermarkets and other internal walls with large traffic and dirty walls.
3 、Pre-curing performance parameters：
Chemical type | Silicone |
Color | White/Grey/Customized |
density | 1.278±0.05g/cm³ |
viscosity（25℃ mpa.s） | 111659 |
Full Fix Time | ≈48 hours |
Surface drying time | ≈20 hours |
4 、Post-cure performance parameters：
Tensile strength（MPa ） | 1.2～1.8 |
Sealing time | Instant sealing |
Hardness (Shore White) | ≈52 |
Elongation | ＞50 |
Benzene content | Not detected |
The sum content of toluene and xylene (including ethylbenzene). | Not detected |
5、Curing properties：
FRS-2000 is primarily cured by reacting with moisture in the atmosphere. Cures in place at room temperature for ease of use. Non-corrosive to metals.
6、How to use:：
①Base treatment: to ensure that the base surface is clean, dry, no oil stains, no floating dust, no mildew, no crisp, no peeling and chalking, if the width of the seam is less than 1mm, it can not be repaired, both sides of the crack must be smooth, if the width of the seam is greater than 1mm, putty can be used to fill it, if there is a serious part of chalking or falling off, waterproof putty treatment can be used to ensure that the base surface is smooth and there is no obvious stubble;
②Construction method: Before using the coating, if you need to add thinner, the reference ratio of paint to thinner is 10:4. Spraying and roller coating can be sprayed twice, and the reference dosage is 1kg/3~4㎡; Roller coating 2 times, the reference dosage is 1kg/5.5~6㎡; The painting interval time is 4~12h, depending on the ambient temperature.
7 、Storage conditions：
①The warehouse for storing paint must be set up in a cool, ventilated and dry place greater than 0°C.
②After opening, the product should be sealed and stored as soon as possible.
③Keep out of reach of children.
8、Precautions
①If the above problems occur, they can be repainted in the defective place;
②Before the coating is fully cured, do not carry out other applications that may damage the coating;
③For unused paint, please seal the inner packaging and store it to avoid curing;
④If the paint gets into your eyes, rinse immediately with water and seek medical attention.
9、illustrate：
The data contained in this article is for informational purposes only and is believed to be reliable. We are not responsible for the results obtained by anyone using methods beyond our control. It is the user's own responsibility to decide which production method to use this product for and which measures to take to prevent loss and personal injury that may occur during the storage and use of the product. If you have any questions, please contact the company's technical department.
